verilog实现led闪烁

verilog实现led闪烁

一、介绍

使用verilog实现代码，实现led闪烁，每间隔200ms进行切换led灯

二、代码

module led (
    input wire clk,
    input wire rstn,

    output wire[3:0] led
);
parameter TIME_200MS = 10_000_000;
reg[1:0] state;
reg[24:0] cnt;
reg[3:0] led_r;
always @(posedge clk or negedge rstn) begin
    if(!rstn)begin
        cnt<=24'd0;
    end
    else if(cnt == TIME_200MS - 1)begin
        cnt<=24'd0;
    end
    else begin
        cnt<=cnt+1'b1;
    end
end
always @(posedge clk or negedge rstn) begin
    if(!rstn)begin
        state<=2'b00;
    end
    else if(cnt == TIME_200MS - 1) begin
        state<=state+1'b1;
    end
    else begin
        state<=state;
    end
	end
always @(posedge clk or negedge rstn) begin
    if(!rstn)begin
        led_r<=4'b0000;
    end
    else begin
        case(state)
            2'b00:led_r <= 4'b0001;
            2'b01:led_r <= 4'b0010;
            2'b10:led_r <= 4'b0100;
            2'b11:led_r <= 4'b1000;
            default led_r<=led_r;    
        endcase
    end
end
assign led = led_r;
endmodule

三、仿真代码

`timescale 1ns/1ns
module led_tb ();
reg clk;
reg rstn;
wire[3:0] led;
parameter MAX_NUM = 10_000;
parameter SYS_CLK = 20;
always #(SYS_CLK/2) clk=~clk;
initial begin
    clk = 1'b0;
    rstn = 1'b0;
    #(SYS_CLK*20);
    rstn = 1'b1;
    #(SYS_CLK*100000);
    $stop;
end
led #(.TIME_200MS(MAX_NUM)) t1(
    .clk(clk),
    .rstn(rstn),
    
    .led(led)
);
endmodule

四、仿真结果

五、总结

控制led闪烁相对吉纳丹，使用一个计数器进行切换即可